User Manual

(1)

Select the bank that contains the scene you want to copy with the Bank

UP/DOWN buttons.

(2)

Press the Midi/Rec button followed by the Scene # button, 1-8, that you want to

copy the scene to. All LED's should flash three times to confirm and save settings.

(5)

Press and hold down the Program button for approximately 2 seconds or until the

PROG indicator in the LED-display stops flashing. A flashing Blackout indicator, in

the LED-display, is indicative that you are out of program mode.

(6)

Copy a Scene

Select the Scene # button, 1-8, that you want to copy.

(3)

Use the UP/DOWN BANK buttons to change the scene bank if desired.

(4)

Delete a Scene

(1)

Select the bank that contains the scene you want to delete with the Bank

UP/DOWN buttons.

(2)

Press and hold down the Program button for approximately 2 seconds or until the

PROG indicator in the LED-display stops flashing. A flashing Blackout indicator, in

the LED-display, is indicative that you are out of program mode.

(5)

Simultaneously, press the Auto/Del button then press the Scene # button, 1-8,

that you want to delete. All LED's should flash three times to confirm that the

scene was deleted.

(3)

Repeat steps 2 & 3 to delete additional scenes.

(4)

Delete All Scenes

(1)

Flip the Operators power switch OFF which is located at the rear of the unit.

(2)

Simultaneously, press and hold down the Program and Bank Down buttons and

flip the power switch ON. All LED's will flash three times to confirm that all

scenes were deleted.

Press and hold down the Program button for approximately 2 seconds or until the

PROG indicator in the LED-display flashes. Once the indicator is flashing, record

mode is engaged and you may release the Program button.

Press and hold down the Program button for approximately 2 seconds or until the

PROG indicator in the LED-display flashes. Once the indicator is flashing, record

mode is engaged and you may release the Program button.

DMX OPERATOR 384