User Manual

(1)
Select the fixtures that you wish to include into your scene by pressing the
FIXTURES # buttons, 1-12. so the selected fixture LED's illuminate.
(2)
Press and hold down the Program button for approximately 2 seconds or until the
PROG indicator in the LED-display flashes. Once the indicator is flashing, record
mode is engaged and you may release the Program button.
Set your scene using the eight Channel faders, joystick or data wheels and
Channel Bank button if needed. The Channel Bank button should be used to
switch between channel banks 1-8, 9-16, 17~24 and 25~32.
(3)
Once you are satisfied with the look of your scene, press the Midi/REC button to
Record it.
(4)
Using the BANK UP & DOWN buttons, select a scene bank to store to. There are
30 available Scene Banks and you can view them in the LED-display by referring
to the furthest two digits to the right.
(5)
Press a Scene button,1-8,to store to.Once pressed,all LED's will flash indicating
that your scene was stored. There are 8 Scene buttons to store to for each bank.
Make sure you select a different scene button each time you store a scene so you
don't record over something that you wanted to keep.
(6)
To Record additional scenes, repeat steps 2 through 6.
(7)
Once you've stored all of your scenes, press and hold down the Program button
or approximately 2seconds to exit. A flashing Blackout indicator in the LED-display,
is indicative that you are out of program mode.
(8)
Recording Scenes
(1)
Using the UP/Down BANK button, select the bank that contains the scene that
you want to edit. You can view the active bank in the LED-display.
(2)
Press the Scene button, 1-8, that you want to edit so the scene comes on.
(3)
Press the Midi/Rec button and then press the scene # button that you are editing.
All LED's will flash three times to confirm that your new settings were saved.
(6)
Editing Scenes
Press and hold down the Program button for approximately 2 seconds or until the
PROG indicator in the LED-display flashes. Once the indicator is flashing, record
mode is engaged and you may release the Program button.
Select the fixture or fixtures that you wish to change settings for in the current
scene by pressing the relevant Fixture # buttons, 1-12. The selected fixture
LED's should illuminate.
(4)
Make your changes using the faders, joystick or data wheels.
(5)
Press and hold down the Program button for approximately 2 seconds to exit. A
flashing Blackout indicator, in the LED-display, is indicative that you are out of
program mode.
(7)
DMX OPERATOR 384
10