User Manual

When powered ON, this console defaults to Manual/Blackout mode. All output will be

in a black-out state until the Blackout button is deselected. To determine blackout

status there is an indicator light in the display that flashes when engaged and OFF

when disengaged. To gain manual control, disengage blackout, select the fixtures

that you wish to control by selecting the relevant fixture buttons on the left then use

the eight channel faders, joystick or data wheels and the channel bank button to

manually control the fixtures. Note: in most cases, for the joystick or data wheels to

work, you must first assign them. Please see the Assign Joystick section of this

manual.

Manual Control

"Delete Pan/Tilt Joystick settings for selected fixtures"

(4) Press and hold down the MODE button, and then tap the Auto/DEL button to

delete the settings for the selected fixtures. All LED's will flash three times to

confirm that the settings were erased.

Delete Joystick Pan/Tilt Assignment

(2) Press and hold down the MODE button and then tap the FINE button. The

"Assign" and "Pan" LED's should illuminate.

(3)

(1)

Press and hold down the Program button for approximately 2 seconds or until the

PROG indicator in the LED-display flashes. Once the indicator is flashing, record

mode is engaged and you may release the Program button.

Select the fixtures that you wish to delete the joystick Pan/Tilt settings for by

pressing the relevant FIXTURES # buttons, 1-12,so the relevant LED's illuminate.

(5)

Press and hold down the Program button for approximately 2 seconds or until the

PROG indicator in the LED-display stops flashing. A flashing Blackout indicator in

the LED-display confirms that the controller is out of Program mode.

"Delete Pan/Tilt Joystick settings for all fixtures"

(1)

Flip the Operators power switch OFF which is located at the rear of the unit.

(2)

Simultaneously, press and hold down the Auto/Del and MODE buttons and flip

the power switch ON. All LED's will flash three times to confirm that the Pan/Tilt

settings were erased.

DMX OPERATOR 384