User Manual

(1)

Press and hold down the Program button for approximately 2 seconds or until the

PROG indicator in the LED-display flashes. Once the indicator is flashing, record

mode is engaged and you may release the Program button.

(2) Press and hold down the MODE button and then tap the FINE button. The "Assign"

and "Pan" LED's should illuminate.

(3)

Select the fixtures that you wish to assign the "Pan Reverse" & "Tilt Reverse" for

by pressing the FIXTURES # buttons, 1-12, so the selected fixture LED's

illuminate. Ideally, you should assign opposite fixtures for Pan/Tilt Reverse. For

example, fixtures 1, 3, 5, 7, etc... should be assigned normal as described in the

previous section and fixtures 2, 4, 6, etc..., should be assigned reversed so that

when moving the joystick around, fixtures movements are reversed from one

another. This feature is traditionally referred to as Pan/Tilt invert.

(5)

Press the Tap/Disp button to switch between "PL.XX" & "PH.XX". "PL.XX"

represents the Low Byte or Fine channel, generally listed as the Pan Fine channel

and PH.XX represents the High Byte or Coarse channel, generally listed as the Pan

channel. Set it to "PH.XX" and press and hold down the MODE button and then tap

the SCENE button that corresponds to the Pan channel of your fixture.For example,

if your fixtures Pan channel is 1 then you'd press the SCENE #1 button. Please

refer to the fixtures DMX chart. If your fixture includes a pan fine channel, press the

Tap/Disp button so the display reads "PL.XX". Press and hold down the MODE

button and then tap the SCENE button that corresponds to the Pan Fine channel

of your fixture. For example, if your fixtures Pan Fine channel is 2 then you'd press

the SCENE #2 button.

(6) Press the BANK UP or DOWN buttons to switch between "TL.XX" & "TH.XX".

"TL.XX" represents the Low Byte or Fine channel, generally listed as the Tilt Fine

channel and TH.XX represents the High Byte or Coarse channel, generally listed as

the Tilt channel. Set it to "TH.XX" and press and hold down the MODE button and

then tap the SCENE button that corresponds to the Tilt channel of your fixture. For

example, if your fixtures Tilt channel is 3 then you'd press the SCENE #3 button.

Please refer to the fixtures DMX chart. If your fixture includes a Tilt Fine channel,

press the Tap/Disp button so the display reads "TL.XX". Press and hold down the

MODE button and then tap the SCENE button that corresponds to the Tilt Fine

channel of your fixture. For example, if your fixtures Pan Fine channel is 2 then

you'd press the SCENE #4 button.

(7)

Press and hold down the Program button for approximately 2 seconds or until the

PROG indicator in the LED-display stops flashing. A flashing Blackout indicator in

the LED-display confirms that the controller is out of Program mode.

(4)

Once again, press and hold down the MODE button and then tap the FINE button.

The "Reverse" LED should illuminate.

DMX OPERATOR 384