User's Manual

ADJ Products, LLC • Los Angeles, Ca USA • Kerkrade, Netherlands

Recall Snapshot

Recalling a snapshot is like saving, select the number from 1-4 then press ENTER.

If DMX-512 frames are being received over the network, they will overwrite any snapshot. The green

LED flashes when DMX-512 frames are being received.

Default Snapshot

Select one of the four saved snapshots (1-4) to be the default settings when the 4 Stream DMX

Bridge is powered on. If there are no incoming Art-Net or sACN data packets, the 4 Stream DMX

Bridge will show the default scene. Any incoming data packets will overwrite this, so it is only useful

when no controller is used, and some kind of output is desired on power-up.

Erase All Memory

Erase all the memory of the 4 Stream DMX Bridge returning everything to the default settings. Hold

down the UP button for 5 seconds until “Reset to erase” message is displayed. Finally reset the 4

Stream DMX Bridge for this change to take effect.

When making this setting change, a system reset is required.

Recall snapshot

1 press enter

Default snapshot

none

Erase all memory

hold ^ 5 sec.

Default snapshot