User's Manual

ADJ Products, LLC • Los Angeles, Ca USA • Kerkrade, Netherlands
17
Station Mode DHCP Enable
Turn DHCP on or off when running in station mode.
When DHCP is enabled, the network router will assign an IP address to the 4 Stream DMX Bridge. This is
convenient on a large network where available IP addresses may not be known.
When DHCP is off, a specific static IP address must be entered, which is described in the next section.
When running the 4 Stream DMX Bridge in sACN mode, IP addresses can be set by the network router
using DHCP as this protocol doesn’t need IP addresses to send messages.
u
When making this setting change, a system reset is required.
DHCP assigned IP Address:
This will let you view the IP address that is assigned by a router when DHCP is enabled in station
mode. This is for information only; no changes are possible from the bridge.
Station Mode Static IP Address
Enter a static IP address if 4 Stream DMX Bridge is running in station mode and DHCP is disabled.
The 4 Stream DMX Bridge uses IPV4 style addresses. The 4 Stream DMX Bridge will try to join a
network using this IP address. Care must be taken to match the IP address to the network’s address
settings. The default address 192.168.000.150 will most likely work (NOT guaranteed) if the network
router is located at address 192.168.000.1 as is most common. If using more than one 4 Stream DMX
Bridge device on a network, set each bridge to a different address by incrementing the last number,
for example 150, 151, etc. for each consecutive 4 Stream DMX Bridge on the network. DHCP can be
used if IP Addressing is unfamiliar.
u
When making this setting change, a system reset is required.
STA IP address
192.168.000.150
STA DHCP enable
enabled
STA DHCP enable
off
DHCP assigned IP
192.168.0.11