Owner's manual

Page 22 American Access Systems / Security Brands, Inc.
CAUTION SHOULD BE TAKEN NOT TO TOUCH CIRCUIT BOARD OR ELECTRONIC COMPONENTS PRIOR TO INSTALLATION TO
AVOID ELECTRO-STATIC DISCHARGE (ESD) DAMAGE.
WARNING
DO NOT APPLY POWER TO UNIT UNTIL
ALL CONNECTIONS ARE MADE AND CHECKED
GENERAL WIRING INSTRUCTIONS
For ease of installation and servicing, the 11-65000 is provided with a terminal board which is connected to the main
unit via a ribbon cable and connector. The screw terminals on the circuit board will accept wire gauges #16 through
#24, solid or stranded. Strip approximately 5/16” (8mm) of insulation, insert into the appropriate hole, and tighten
with a small screwdriver. Tinning is strongly recommended for stranded wires (see Figure 2 for proper terminations).
Arrange a cable drip loop on all exterior installations.