User guide

Speedway Reader IPJ-R1000 for Gen 2 UHF RFID

1. Setting Up the Speedway Reader

Your Speedway reader has been shipped with the following:

• Speedway reader unit

• Power supply module (CUI, Inc., P/N DTS240250UC-P11P-DB) with 24VDC output (power supply module ordered

separately). Note: the use of any other power supply module may cause damage to the reader.

• Several Impinj Monza™ Gen 2 tags to aid Speedway setup and system verification

1.1. Other System and Equipment Requirements

Table 1-1summarizes the supported operating environments.

Table 1-1 Operating Environments

Interface Protocol Recommended Tools

Windows Linux Mac/Other

Web Interface

HTTP Any browser that supports Java

Remote Login SSH/Telnet Putty SSH or Telnet Terminal

Serial RS-232 Hyperterminal Minicom N/A

The components and accessories detailed below are required in order to ensure compliance with the Speedway reader. It is the

responsibility of the user or professional installer to provide and properly use all these components and accessories:

• A PC running Windows 2000 (or higher), XP, or Linux PC, and

- An available RS-232 serial port (required only if system does not support DHCP)

- An Ethernet port

• http browser that includes Java Runtime Environment (JRE) of version 1.4.2 or later. Note that Windows 2000 default is

version 1.3.1. The latest version of JRE can be downloaded from: http://www.java.com/en/download/manual.jsp

(to

determine/verify your version, go to http://www.java.com/en/download/installed.jsp).

• Standard, grounded DB9 serial cable (required only if system does not support IP provisioning)

• An Ethernet port

• Standard Ethernet cable(s)

• TCP/IP network equipment, as required to connect the reader to a PC, Mac, or other

• Impinj-approved UHF RFID antenna(s), including associated RF cable with RP-TNC male connector interface