Operating instructions

Page 15 © American Access Systems
NOTES:
- Be sure to make a note of the new Master Code. It is the password to system operation.
- If the Master Code has been forgotten or lost, and you cannot enter Sub-Mode 3, you must
perform a Master Reset which will reset the Master Code to 1 2 5 1. You can then use Sub-
Mode 3 to change the Master Code.
Set Sleep Code -- Sub-Mode 4
DETAILS: The Sleep Code is used to disable all Relay A and Function Codes from the keypad. This feature is
most commonly used in applications where no entry is desired after hours. Relay B codes will continue to
be valid from the keypad. By connecting both relays in parallel, managers may be assigned Relay B
codes and still gain access. While in the SLEEP MODE, the yellow and red LED's will flash every 3 seconds.
To initialize the system back to normal, simply re-enter the Sleep Code. Should you lose or forget the Sleep
Code and the unit is in the sleep mode you must complete a Master Reset. See the instructions on pages
20 and 21.
To program or change the Sleep Code:
- Enter the current Master Code
- Press the numeral 4
- Unit will sound a GOOD TONE
- Enter a new Sleep Code (If you hear an ERROR TONE, select another code that is not already in
use)
- Unit will sound a GOOD TONE
- If you make an entry error, simply press the star (Å) key and enter the number you wish
- When the new Sleep Code is accepted you will hear a GOOD TONE
- Press the pound
(#) key to exit the programming mode