Operating instructions

Page 13 © American Access Systems
Program Relay “A” Access Codes - Sub-Mode 1
To program Relay “A” access codes, use the following steps:
- Enter 1 2 5 1 (or, if the factory MASTER CODE has been changed, enter the programmed
MASTER CODE)
- Unit will sound a GOOD TONE
- Enter the numeral 1
- Unit will sound a GOOD TONE
- Enter a four-digit code combination other than the MASTER CODE (for example enter 4 3 2 1)
- If you receive an ERROR TONE after an entry it means that particular code is already assigned
and you must select another code
- If you make a mistake during entry, press the star (Å) key, then re-enter the code.
- When a new code is accepted the unit will sound a GOOD TONE
- Continue to enter codes until you are finished
- When you are done, press the pound (#) key to exit the programming mode
NOTES: You will automatically be exited from the programming mode IF:
 The memory reaches capacity
 The memory is full, you will not be able to enter Sub-Mode 1 and you will receive an ERROR TONE if
you try to enter this Sub-Mode.
 To enter new codes if the memory is full, you must first delete codes some of the codes already in
memory.
 Contact AAS if there seems to be a problem programming additional codes.