Specification

CONTROL ROUGH-IN INSTRUCTIONS
4211-137 page 2 of 2 04/05/10
Run a bead of silicone around the back of the control
then use the 2 screws provided to add the retaining
bracket to the back of the control. Note: you may
need to rap the screws lightly to break through the
switch housing’s screw hole moisture barriers.
Run the cable end through the bracket and plug it into the control
Push the bracket through the hole and push the control into the
wall. Carefully align the control vertically and horizontally while
inserting it into the hole.
Tighten the bracket screws until the control is pulled snuggly
against the wall. Do not over tighten – this may damage the
control and cause vapor leaks!
Mount the decorative cover plate by first hanging
it onto the top of the control housing then pushing
the bottom of the plate until it clicks into place.