User manual

Appendix A AT Command Summary
Page 39 Dec 2009
Appendix A AT Command Summary
The ELPRO 605M-D1 supports the following AT Commands. The following list provides a summary of the supported
AT commands. For a detailed list of the AT command functionality, contact ELPRO support.
General Configuration Commands - AT Interface Backward Compatibility
#SELINT Select Interface Style
Hayes AT Commands - Generic Modem Control
&F Set To Factory-Defined Configuration
Z Soft Reset
+FCLASS Select Active Service Class
&Y Designate A Default Reset Basic Profile
&P Designate A Default Reset Full Profile
&W Store Current Configuration
&Z Store Telephone Number In The Module
Internal Phonebook
&N Display Internal Phonebook Stored Numbers
+GMI Manufacturer Identification
+GMM Model Identification
+GMR Revision Identification
+GCAP Capabilities List
+GSN Serial Number
&V Display Current Base Configuration And Profile
&V0 Display Current Configuration And Profile
&V1 S Registers Display
&V3 Extended S Registers Display
&V2 Display Last Connection Statistics
\V Single Line Connect Message
+GCI Country Of Installation
%L Line Signal Level
%Q Line Quality
L Speaker Loudness
M Speaker Mode
Hayes AT Commands - DTE-Modem Interface Control
E Command Echo
Q Quiet Result Codes
V Response Format
X Extended Result Codes
I Identification Information
&C Data Carrier Detect (DCD) Control