User manual

Chapter 4 Configuration
Page 17 Dec 2009
Alternatively, you can remove the SIM card from
the 605M-D1 modem on startup which aborts the
automated connection and returns to the AT
command mode.
NOTE: Once the modem goes into the automated
connection mode it takes control of the RS232
port and you are not able to communicate to it
using AT commands. The modem will need to be
power cycled to get back the AT command mode.
4.1.3 Configuration
The configuration software lets users configure the automated connection mode for the ELPRO 605M-D1 modems
through an easy to use graphical user interface. It eliminates the need for the user to remember complex AT
commands.
The configuration software can also be used to conveniently Save/Load configuration data To/From a file on a
storage medium. This is very handy to quickly deploy a configuration profile to multiple modems or for backup
purposes.
We don’t actually need to be connected to the 605M-D1 modem while modifying the various configuration settings.
The modem needs to be connected only while performing a modem Read/Write operation or while running
diagnostics.
Various configuration settings are required by the 605M-D1 modems to successfully enable the M2M automated
connection mode. The different configuration settings and other features are discussed in detail in the following
sections.
Advanced Config :
Some settings in the configuration software are
disabled by default. These settings are
generally not meant to be changed and are
only for advanced users. Any such advanced
settings are highlighted throughout this
document.
In case you need to enable these advanced
settings, from the command menu click on
View > Advanced Config or use the shortcut
key Ctrl+F12.
WARNING: Advanced settings are only meant for advanced users. Changing these from defaults may cause
connection and data flow problems.