Installation guide

SS3GR1028F Series Installation Guide Chapter 1 Introduction
On (Orange)
Port2 of M1 is not at link state, but
M1 is in place
On (Green)
Port1 of M2 is at link state
On (Green,
Blink)
Port1 of M2 is receiving or sending
the data
M2-1
Off
Port1 of M2 is not at link state
On (Green)
Port2 of M2 is at link state
On (Green,
Blink)
Port2 of M2 is receiving or sending
the data
Off
Port2 of M2 is not at link state
M2-2
On (Orange)
Port2 of M2 is not at link state, but
M2 is in place
1.4.5 Interface Description of Front Panel
Provides RJ-45 1000Mb copper port and the interface of SFP 1000Mb fiber
transceivers.
Table 1-6 interface descriptions
Interface mode Spec
RJ-45 port
• 10/100/1000Mbps auto negotiation
• MDI/MDI-X cable mode auto negotiation
• 5 kinds of UTP: 100 m
SFP
• SFP-SX-L transceiver
1000Base-SX SFP(850nm,MMF,550m)
• SFP-LX-L transceiver
1000Base-LX SFP(1310nm, SMF, 10km or
MMF, 550m)
• SFP-LX-20-L transcever
1310nm lightwave, 9/125um single mode
fiber: 20km
• SFP-LX-40 transceiver
9/125um single mode fiber: 40km
• SFP-LH-70-L transceiver
9/125um single mode fiber: 70km
• SFP-LH-120-L transceiver
9/125um single mode fiber: 120km
SFP-GT
• SFP-GT Module:
1000Base-T SFP interface card module,
RJ-45 interface
1-7