Installation guide

SS3GR1028F Series Installation Guide Chapter 2 Hardware Installation
2.3.5 SS3GR10SFP+ extended module Installation
The SS3GR1028F series provide 10Gb slots. The procedure for installing the
SS3GR10SFP+ module and the SFP+ 10Gb fiber transceiver is shown below:
Step 1: Put on an ESD wrist strap (or antistatic gloves).
Step 2: Insert the SS3GR10SFP+ module to the guide rail inside the 10Gb module slot.
Step 3: Push the SS3GR10SFP+ module along the guide rail gently until it comes into
contact with the machine panel.
Step 4: Insert the SFP+ transceiver to the guide rail inside the SS3GR10SFP+. Do not put
the XFP transceiver up-side-down.
Step 5: Push the SFP+ transceiver along the guide rail gently until it comes into contact
with the SS3GR10SFP+.
Note: the SFP+ 10Gb fiber transceiver is hot swappable. SS3GR10SFP+ extended
module can insert SFP 1Gb fiber transceiver.
2.3.6 SS3GR10SFP Extended module Installation
The SS3GR1028F series provide 10Gb slots. The procedure for installing the
SS3GR10SFP module and the SFP 1Gb fiber transceiver is shown below:
Step 1: Put on an ESD wrist strap (or antistatic gloves).
Step 2: Insert the SS3GR10SFP module to the guide rail inside the 10Gb module slot.
Step 3: Push the SS3GR10SFP module along the guide rail gently until it comes into
contact with the machine panel.
Step 4: Insert the SFP transceiver to the guide rail inside the SS3GR10SFP. Do not put
the SFP transceiver up-side-down.
Step 5: Push the SFP transceiver along the guide rail gently until it comes into contact with
the SS3GR10SFP.
Note: the SFP 1Gb fiber transceiver is hot swappable.
Caution!
Do not stare directly at the 2 fiber bores in the fiber transceiver when the switch is in
operation, otherwise the laser may hurt your eyes.
2.3.7 Copper Cable/Fiber Cable Connection
Copper cables should be connected as below:
2-8