User manual

SS2R24G4i/SS2R48G4i
75
7.2.3.4 Device Mirroring Troubleshooting
7.2.3.4.1 show monitor
Command show monitor
Function To display the source and destination port information of the image.
Command Mode Admin Mode
Display information Explanation
session number Session number of the image
Source ports Source ports of the image
RX The image in the receiving direction of the
port.
TX The image in the transmitting direction of
the port.
Both The images in both the receiving and
transmitting directions of the port.
Destination port Destination port of the image
7.2.3.4.2 debug mirror
Command debug mirror
no debug mirror
Function
To enable the debug information of the mirror, the “no debug mirror”command is used to disable the
debug information of the mirror.
Command Mode Admin Mode
7.2.3.4.3 Device Mirroring Troubleshooting
If problems occurs on configuring port mirroring, please check the following first for causes
& Whether the mirror destination port is a member of a trunk group or not, if yes, modify the trunk
group.
& If the throughput of mirror destination port is smaller than the total throughput of mirror source
port(s), the destination port will not be able to duplicate all source port traffic; please decrease the
number of source ports, duplicate traffic for one direction only or choose a port with greater
throughput as the destination port.