User manual

SS2R24G4i/SS2R48G4i

Command show flash

Function Display the document in the flash

Command Mode Admin Mode

5.2.5.5 show history

Command show history

Function Display the recent user input history command

Command Mode Admin Mode

5.2.5.6 show memory

Command show memory

Function Display the contents in the memory

Command Mode Admin Mode

5.2.5.7 show rom

Command show rom

Function Display enable document and bulk

Command Mode Admin Mode

5.2.5.8 show running-config

Command show running-config

Function Display the current active configuration parameters for the switch.

Default If the active configuration parameters are the same as the default operating parameters,

nothing will be displayed.

Command mode Admin Mode

5.2.5.9 show startup-config

Command show startup-config

Function Display the switch parameter configurations written into the Flash memory at the current

operation; those are usually also the configuration files used for the next power-up.

Default If the configuration parameters read from the Flash are the same as the default operating

parameter, nothing will be displayed.

Command mode Admin Mode

5.2.5.10 show switchport interface

Command show switchport interface [ethernet <interface-list>]

Function Show the VLAN port mode, VLAN number and Trunk port messages of the VLAN port

mode on the switch.

Parameter <interface-list> is the port number or port list, which could be maximum of 0/0/1 port in