User manual

SS2R24G4i/SS2R48G4i
187
entry.
Port Physical (Layer2) interface corresponding
to the ARP entry.
Flag Describes whether ARP entry is dynamic or
static.
23.2.2.1.2 debug arp
Command debug arp
no debug arp
Function Enable the ARP debug function the “no debug arp” command disables this debug
function.
Default ARP debug is disabled by default.
Command mode Admin Mode
23.2.2.2 ARP Troubleshooting Help
If ping from the switch to directly connected network devices fails, the following can be used to check
the possible cause and solution.
z Check whether the corresponding ARP has been learned by the switch.
z If ARP is not learned, then enabled ARP debug information and view sending/receiving condition of
ARP packets.