Installation guide

Chapter 1 Introduction
1.1 Product Brief
SS3GR50i/26i front panel:
Figure 1-1 SS3GR50i and SS3GR26i Switch
1.1.1 Overview
SS3GR50i/26i switch switch are 10Gb Ethernet routing switch. The switch has 48/24 fixed
1000Mb copper ports (44/20 1000Mb ports and 4 1000Mb COMBO ports) and 2 fixed 10Gb XFP
ports and 2 fixed 10Gb stacking ports.SS3GR50i/26i switch switch are based on 10Gb switching
technology. The switches fully support IPv6, whereas their height is only 1U. As distribution layer
switches which are featured in high performance, small size and flexibility, SS3GR50i/26i switch
switch with advanced intelligent and secure features, can serve ideally as distribution layer
switches for campus networks, enterprise networks and IP metropolitan networks; as well as core
layer switches for small and medium-sized networks.
The rear panel provides two slots for single-port 10 Gigabit Ethernet hot-swappable
expansion modules, and two stacking ports. Units can be stacked up to eight high through the
built-in stacking ports that provide a 48 Gbps stack backplane.
The switches include an SNMP-based management agent embedded on the main board,
which supports both in-band and out-of-band access for managing the stack. These switches can
easily tame your network with full support for Spanning Tree Protocol, Multicast Switching,
Virtual LANs, and IP routing. It brings order to poorly performing networks by segregating them
1-1