System information

Publication date: Feb., 2012
Revision A1
- 84 -
CLIReferenceGuide
Copyright @ 2012 by Amer Networks
Chapter 24 LACPCommandsofCLI
LACP
Ports using Link AggregationControl Protocol(according to IEEE802.3ad
specification) as their trunking method can choose their unique LACP
GroupIDtoformalogic“trunkedport”.ThebenefitofusingLACPisthata
port makes an agreement with its peer port before it becomes a ready
memberofa
“trunkgroup”(alsocalledaggregator).LACPissaferthanthe
othertrunkingmethod‐statictrunk.
Table 23: LACP Commands
Command Function
clear
Clear command
key
Configure the LACP key
mode
Configure the LACP mode
role
Configure the LACP role
Show
Show LACP information
clear: Thiscommandletsyouclearthelinkaggregation
entryonswitch.
Syntax:
clear statistics
Parameter :
statistics: Clear LACP statistics.
EXAMPLE:
key: ThiscommandletsyouconfiguretheLACPkey.
Syntax:
key <port-list> <1-65535>/ auto
Parameter :
<port-list> available value is from switch physic port density, format:
1,3-5
<1-65535>: LACP key
auto: The Auto setting will set the key as appropriate by the physical
Switch(lacp)# clear statistics
Switch(lacp)# show statistics
Port Rx Frames Tx Frames Rx Unknown Rx Illegal
---- ---------- ---------- ---------- ----------
1 0 0 0 0
2 0 0 0 0
3 0 0 0 0
4 0 0 0 0