System information

Publication date: Feb., 2012
Revision A1
- 82 -
CLIReferenceGuide
Copyright @ 2012 by Amer Networks
Chapter 23 IPv6CommandsofCLI
IPv6
This section describes how to configure the switch‐managed IPv6
information. The Configured column is used to view or change the IPv6
configuration. And the Current column is used to show the active IPv6
configuration.
Configuretheswitch‐managedIPv6inf ormationonthispage.
TheConfiguredcolumnisusedtoview
orchangetheIPv6configuration.
TheCurrentcolumnisusedtoshowtheactiveIPv6configuration.
Table 22: IPv6 Commands
Command Function
autoconfig
Configure IPv6 autoconfig mode
setup
Set the IPv6 address
show
Show IPv6 information
autoconfig: ThecommandletsyouconfigureIPv6autoconfig
mode.
Syntax:
autoconfig disable/ enable/ renew
Parameter :
disable: Disable autoconfig mode
enable: Enable autoconfig mode
renew: Force to renew IPv6 address
EXAMPLE:
setup: ThecommandletsyousettheIPv6addre ss
Syntax:
setup <ipv6-address> <deny> <permit>.
Parameter :
<ipv6-address>: IPv6 address is in 128-bit records represented as
eight fields of up to four hexadecimal digits with a colon separates each
field (:).
For example, 'fe80::215:c5ff:fe03:4dc7'. The symbol '::' is a special
syntax that can be used as a shorthand way of representing multiple
Switch(ipv6)# autoconfig enable
Switch(ipv6)# show config
Auto Configuration : Enabled
Address : ::192.168.1.1
Prefix : 96
Gateway : ::