System information

Publication date: Feb., 2012
Revision A1
- 6 -
CLIReferenceGuide
Copyright @ 2012 by Amer Networks
Chapter 1 OperationofCLIManagement

Initial
Configuration
This chapter instructs you how to configure and manage the L2 PLUS
ETHERNET SWITCH through the CLI interface.With this facility, you can
easilyaccessandmonitorthroughconsoleportoftheswitchallthestatus
oftheswitch,includingMIBsstatus,eachportactivity,Spanningtreestatus,
port aggregation status, multicast traffic, VLAN and priority status, even
illegalaccessrecordandsoon.
Theserialport’sconfigurationrequirementsareasfollows:
◆ DefaultBaudrate—115,200bps
◆ CharacterSize—8Characters
◆ Parity—None
◆ Stopbit—One
◆ Databits—8
◆ Flowcontrol—no ne
The default username is “admin” and password is empty. For the
firsttimetouse ,pleaseenterthedefaultusernameandpassword,
and then click the Enter button. The login process now is
completed.
About Null Console Cable identity:
Figure 1: Serial Port (DB-9 DTE) Pin-Out
TheDB‐9cableisusedforconnectingaterminalorterminalemulatorto
theManagedSwitch’sRS‐232porttoaccessthecommand‐lineinterface.
ThetablebelowshowsthepinassignmentsfortheDB‐9cable.
Function Mnemonic Pin
 Carrier CD1
 ReceiveData RXD2
 TransmitData TXD3
DataTerminalReady DTR 4
 SignalGround GND5
 DataSetReady DSR6
RequestToSend RTS 7
 ClearToSend CTS8