System information

Publication date: Feb., 2012
Revision A1
- 50 -
CLIReferenceGuide
Copyright @ 2012 by Amer Networks
Chapter 14 EventCommandsofCLI
Event
ThefunctionisusedtosetanAlarmtrapandgettheEventlog.TheTrap
EventsConfigurationfunctionisusedtoenabletheswitchtosend outthe
trapinformationwhilepre‐definedtrapevent soccurred.

Table 13: Event Commands
Command Function
group
Configure trap event severity level
show
Show trap event configuration
group: Thecommandletsyoutoconfiguretrapeventseverity
level
Syntax:
Group <group-name><port-list>
Parameter :
<group-name>
T
rap event group name
<0-7> Severity level
<0> Emergency: system is unusable
<1> Alert: action must be taken immediately
<2> Critical: critical conditions
<3> Error: error conditions
<4> Warning: warning conditions
<5> Notice: normal but significant condition
<6> Informational: informational messages
<7> Debug: debug-level messages
EXAMPLE:
Switch(event)# group acl 5
Switch(event)# show
Group Name Severity Level
-------------------------------- ----------------
ACL Notice
ACL_Log Debug
Access_Mgmt Info
Auth_Failed Warning
Cold_Start Warning
Config_Info Info
Firmware_Upgrade Info
Import_Export Info
LACP Info
Passwd_Change Info
Port_Security Info
Thermal_Protect Info
VLAN Info
Warm_Start Warning
Switch(event)#