System information

Publication date: Feb., 2012
Revision A1
- 210 -
CLIReferenceGuide
Copyright @ 2012 by Amer Networks
Chapter 46 ThermalProtectionCommandsofCLI
Thermal
The section describes the user to inspect and configure the current
setting for c ontrolling thermal protection. Thermal protection is used to
protectthechipfromgettingoverheated.
When the tempera ture exceeds the configured thermal protection
temperature, ports will be turned off in order to decrease the power
consumption. It is possible
 to arrange the por ts with differentpriorities.
Each priority can be given a temperature at which the corresponding
portsshallbeturnedoff.
Table 45: Thermal Protection Commands
Command Function
port-priority
Configure the port priority
priority-temp
Configure the temperature at which the ports shall be
shut down
show
Show thermal protection information
port‐priority: ThecommandletsyouConfiguretheportpriority

Syntax:
port-priority <port-list> <0-3>
Parameter :
<port-list>: available value is from switch physic port density, format:
1,3-5
<0-3>: Port priority
EXAMPLE:
priority‐temp: ThecommandletsyouConfigurethetemperatureat
whichtheportsshallbeshutdown
Switch(thermal)# port-priority 1 3
Switch(thermal)# show
Priority Temperature
-------- -----------
0 255 C
1 255 C
2 255 C
3 255 C
Port Priority Chip Temperature Port status
---- -------- ---------------- ---------------------------------------------
1 3 60 C Port link operating normally
2 0 59 C Port link operating normally
3 0 59 C Port link operating normally