System information

Publication date: Feb., 2012
Revision A1
- 195 -
CLIReferenceGuide
Copyright @ 2012 by Amer Networks
p‐edge: The command lets you Set the STP adminEdge port
parameter
Syntax:
p-edge aggregations
/
<port-list> disable/ enable
Parameter :
aggregations: available value is for aggregated port
<port-list>: available value is from switch physic port density, format:
1,3-5
disable: disable: Disable MSTP protocol
enable: enable :
Enable MSTP protocol
EXAMPLE:
Switch(stp)# p-edge aggregations enable
Switch(stp)# show pconf
Port Mode AdminEdge AutoEdge restrRole restrTcn bpduGuard Point2point
---- -------- ------------------ ------------------ ---------------------
Aggr Disabled Enabled Enabled Disabled Disabled Enabled Enabled
Port Mode AdminEdge AutoEdge restrRole restrTcn bpduGuard Point2point
---- -------- ------------------ ------------------ ---------------------
1 Disabled Disabled Disabled Disabled Disabled Enabled Auto
2 Disabled Disabled Enabled Disabled Disabled Disabled Auto
Switch(stp)# p-cost 0 aggregations 2000000
Switch(stp)# show p-config 0
MSTI Port Path Cost Priority
---- ---- ---------- --------
CIST Aggr 2000000 128
MSTI Port Path Cost Priority
---- ---- ---------- --------
CIST 1 Auto 128
CIST 2 Auto 128
CIST 3 Auto 128
Switch(stp)# p-cost 1 3 9999
Switch(stp)# show p-config 1
MSTI Port Path Cost Priority
---- ---- ---------- --------
MSTI1 Aggr Auto 128
MSTI Port Path Cost Priority
---- ---- ---------- --------
MSTI1 1 Auto 128
MSTI1 2 Auto 128
MSTI1 3 9999 128