System information

Publication date: Feb., 2012
Revision A1
- 148 -
CLIReferenceGuide
Copyright @ 2012 by Amer Networks
port-shaper
Port shaper
qce
Add or modify QoS control entry
queue-shaper
Queue shaper
show
Show QoS information
storm
Configure storm rate control
tag-remarking
QoS egress port tag remarking
show
Show the GVRP configuration
delete: ThecommandletsyoudeleteQCE
Syntax:
delete <1-256>
Parameter :
<1-256>: QCE ID must be exist
EXAMPLE:
NOTE: If you set the GVRP on port then you could show the
port GVRP statistics information or clear all record on port.
dscp‐classification:
The command lets you configure DSCP ingress
classification
Syntax:
dscp-classification map <class-list> <0-63>
mode <dscp-list> disable/ enable
Parameter :
map: Configure DSCP ingress classification mapping table. This table is
used to map DSCP from QoS class and DP level. The DSCP which needs
to be classified depends on port DSCP classification and DSCP
classification mode. Incoming frame DSCP may be translated before
using the value for classification
<class-list>: QoS class list, available value is from 0 to 7
<0-63>: Mapped DSCP
mode: Configure DSCP ingress classification mode. If port DSCP
classification is 'selected', DSCP will be classified based on QoS class
and DP level only for DSCP value with classification mode 'enabled'.
DSCP may be translated DSCP if translation is enabled for the port
<dscp-list>: DSCP list, format : 1,3,5-7
disable: Disable DSCP ingress classification
enable: Enable DSCP ingress classification
Switch(qos)# delete 1