User`s guide

Installing Fiber Adapter into PCI slot

Step 1: Turn off the power to the PC.

Step 2: Remove any metal decorations from your hands and wrists.

Step 3: Remove the cover from your PC.

Step 4: Locate an empty, non-shared bus mastering 32bit or

64bit PCI slot and remove the corresponding backplate.

Save the screw for use in Step 6.

Step 5: Carefully insert the Fiber Adapter into the chosen slot

and press firmly with proper push to ensure it is fully

seated in the slot.

Step 6: Secure the Fiber Adapter with the screw you saved in step 4.

Step 7: Replace the PC cover.

Step 8: Proceed to “Connecting to Your Network” section.

<Note>

Always ensure power is off before any installation to avoid electric shock and possible damage

to equipment.

Connecting the Fiber ( SC ) Cable

A Multi-mode Fiber cable (50/125µm or 62/125µm, wavelength 850nm)

with SC connector is required for the Gigabit fiber Ethernet Card.

For cabling requirements and maximum segment distance when connecting the Fiber

Adapter to your network, please refer to the Technical Specifications on page 11.