Specifications

LBS Stereo Input Channel

HF The HF control gives 18dB of cut or boost switchable at frequencies 6kHz or

12kHz.

LF The LF control gives 18dB of cut or boost. The frequency switch selects

between 40 Hz and 80Hz.

Using the X3 switch multiplies the selected frequencies by three giving a

selection of 120Hz or 240Hz.

MF The MF cut and boost control gives a range of ± 14dB. The HMF frequency

control gives a variable frequency range of 80Hz to 5kHz. Using the X3

switch multiplies the selected frequencies by 3 giving a range of 240Hz to

15kHz.

Using the Q switch selects either 0.7 or 1.3 Q Factor.

HI-PASS Filter

The HP switch inserts a HI-PASS filter into the signal path.

The -3dB point is fixed at 80Hz at 18dB per octave.

Power Consumption

10–4–2BB100 Console 0.5kVA

32–8–2BB100 Console 1.2kVA

Notes:-

1. 0dBu = 0.775 Volts.

2. Published specifications apply to standard consoles.

3. All measurements taken using the Audio Precision System One test set.

4. Where no load impedance is specified, the equipment should be loaded

with 10K ohms or greater.

5. These figures are typical of performance in a normal electromagnetic

environment. Performance may be degraded in severe conditions.

6. Amek has an established policy of seeking improvements to designs,

specifications and manufacture of its products. Alterations take place

continually, often without notice outside the company. Amek’s literature

must not be taken as an infallible guide to the specifications available

despite a considerable effort to produce up to date information.