Specifications

LB6 Aux Master Comms Module

Jumper and Switch Options – GL 1868

User Tally / On Air Select

To select the internal User Tally indicator, link pins1–3

(Factory Pre-set).

To select the external User Tally, link pins3–5.

Applying an active low to a pin on the 25 way D Type

connector controls the external User Tally.

This is located on the back panel.

To activate On Air Mode, link pins4–6(Factory Pre-set).

To disable it, link pins2–4.

Slate Destination Select

To enable the oscillator to slate to the Stereo Bus, link pins

1 – 3 (Factory Pre-set).

To enable it to slate to the Group Buses, link pins2–4

(Factory Pre-set).

To disable slate to the Stereo Bus, link pins3–5.

To disable the slate to the Group Buses, link pins4–6.

Comms Output / Comms to Monitor 2

To enable the comms signal to route to the Comms

output, link pins3–5(Factory Pre-set).

For the oscillator to route to the Comms output link pins

1–3.

To enable the comms signal to route to the Monitor 2

output, link pins4–6.

To disable the comms to Monitor 2, link pins2–4

(Factory Pre-set).