Specifications

P5
Return Aux Send Bus Select
To select Aux buses1&2,link pins4–6and3–5
(Factory Pre-set).
To select Aux buses3&4,link pins1–3and2–4.
P6
Group Bus Select
These jumpers should be set for the appropriate Group
buses.
To select Groups1&2,link pins1–2and3-4.
To select Groups3&4,link pins5–6and7-8.
To select Groups5&6,link pins9–10and11-12.
To select Groups7&8,link pins 13 – 14 and 15 - 16.
Note: - Only link one pair of buses per module.
P7
Remote Mute / VCA Control Select
To enable the remote mute facility on the Group module,
link pins1-2(Factory Pre-set).
Applying an active low to a pin on the 25 way D Type
connector controls the remote mute. This is located on the
back panel. To disables the remote mute and enables the
optional VCA control, link pins2–3.
P8
Signalisation Select
To disable the Group fader start switch; link pins
1 – 2 (Factory Pre-set).
To enable the Group fader start switch; link pins2–3.
S16
Group Sends Aux
When the switch is pressed in, the Group sends are Aux
sends 1 to 4 (Factory Pre-set).
5-20 Modules Issue 3 © AMEK