Specifications

LB2 Dual Group Module

Jumper and Switch Options – JP 1866

Cleanfeed Off Group Source

To route the signal from the Aux Pre / Post switch and

send it to the Cleanfeed output, link pins3–5and4–6.

E.g. If the module is Groups1&2,Groups1&2will be

sent to Cleanfeed 1. To disables the function, link pins1–3

and2–4(Factory Pre-set).

Cleanfeed Jumper

Linking pins3–5(Factory Pre-set) enables the chosen

Cleanfeed bus to be connected to the Cleanfeed mix amp.

Linking pins1–3disconnects Cleanfeed bus from the

Cleanfeed mix amp. Linking pins4–6(Factory Pre-set)

sends the Cleanfeed cancellation signal to the Cleanfeed

mix amp. This signal is out of phase and will cancel out any

identical signal on the selected Cleanfeed bus.

Linking pins2–4disables the Cleanfeed cancellation signal.

Cleanfeed Bus Selection

This allows you to select the appropriate Cleanfeed buses.

To connect Cleanfeed bus 1 to the module in the first

group position, link pins7–8.

To connect Cleanfeed bus 2 to the module in the second

group position; link pins5–6.

To connect Cleanfeed bus 3 to the module in the third

group position, link pins3–4.

To connect Cleanfeed bus 4 to the module in the fourth

group position link pins1–2.

Note: - In a four Group console Cleanfeed buses 3 and 4 will be used for

Cleanfeed outputs1&2.Only link one bus per modules.