Specifications

Auxiliary Sends

9. Signal is sent to the Aux 1-8 buses via the eight LEVEL controls. All the

Auxs have unity gain when the controls are fully clockwise and are switched

pre or post in pairs by the PRE switches.

10. Auxs1&2hasaninternal switch option to configure the Aux to a Stereo

level/pan arrangement.

Routing

11. The Pan control feeds the signal to the Stereo mix and the groups. Panning

left pans to the odd groups and Stereo left, panning right pans to the even

groups and Stereo right. In the centre position there is a drop of -3dB.

12. The Group Disable switch when selected disables panning across the

groups.

13. The Mute switch cuts off all output from the channel and utilises a soft

mute for click free switching.

14. The PFL switch provides a pre fade signal to the monitor speakers replacing

the selected source. There is an internal switched option, which allows the

PFL to become After Fade listen.

15. The Fader is the main level control for the channel. It has 10dB of gain at

the top of travel.

16. The Group switches assign the signal in pairs to the group buses. The

source signal can be pre or post pan as selected by the Group Disable

switch. Groups are available only if the appropriate amount of group

modules is fitted.

17. The Stereo switch assigns the signal to the Stereo bus.

18. The four segment PFL meter displays the channel pre-fade level.

The meter monitors the signal pre and post EQ simultaneously.

The O/L led illuminates when the signal reaches +18dB.

19. A Ground Compensated Direct Output is provided which is normally

feed from the post fade signal (Factory Pre-set) but can be selected to be

pre fade/post mute or pre EQ by internal jumpers.

The Direct Outputs are fed to jacks on the rear panel.