Specifications

Fader Starts / Monitor Logic / Remote Mutes
Fader Start
The Fader Start switch allows tape recorders or similar equipment to be remote
started. The connection is designed for use with 5 volt (TTL/CMOS type) logic
systems and is controlled by an active low. Internal module jumpers select
whether or not the TALLY Led can be controlled internally or externally. The
TALLY Led when set to external is controlled by applying an active low to a pin
on the D Type connector located on the rear panel. If the internal Tally as been
selected then the LED is directly driven of the fader start system.
Monitor Logic / Remote Mutes
The Monitor Logic and the Remote Mutes are controlled by applying an active
low to a pin on the D Type connectors located on the rear panel.
4-6 Connectors Issue 3 © AMEK
Note: All controls are activated
by an active LOW
Fader Starts
Monitor Logic
25 Way Female D Type
Viewed From OUTSIDE The Console
25
1
Pin 1: Chassis Ground
Pin 2: User Switch O/P
Pin 3: External Talkback Control
Pin 6: Remote Mute Control (Pos 13)
Pin 7: Remote Mute Control (Pos 11)
Pin 5: Group Mute Control (GRP1) (Option)
Pin 4: Group Mute Control (GRP3) (Option)
Pin 8: Remote Mute Control (Pos 9)
Pin 9: External Fader Start (Pos 12)
Pin 10: External Fader Start (Pos 11)
Pin 13: A Ground
Pin 14: User Tally Control
Pin 12: External Fader Start (Pos 9)
Pin 11: External Fader Start (Pos 10)
Pin 15: Remote User In
Pin 16: Group Mute Control (GRP 4) (Option)
Pin 17: Group Mute Control (GRP 2) (Option)
Pin 20: Remote Mute Control 10
Pin 21: Remote External Tally Control 12
Pin 19: Remote Mute Control 12
Pin 18: Studio Remote Cut
Pin 22: Remote External Tally Control 11
Pin 23: Remote External Tally Control 10
Pin 24: Remote External Tally Control 9
Pin 25: Analogue Ground
Fader Starts
Remote Mutes
15 Way Female D Type
Note: All controls are activated
by an active LOW
15
1
Pin 1: Chassis Ground
Pin 2: Remote Channel Mute (Pos 3)
Pin 3: Remote Channel Mute (Pos 1)
Pin 6: External Fader Start (Pos 2)
Pin 7: External Fader Start (Pos 1)
Pin 5: External Fader Start (Pos 3)
Pin 4: External Fader Start (Pos 4)
Pin 8: A Ground
Pin 9: Remote Channel Mute (Pos 4)
Pin 10: Remote Channel Mute (Pos 2)
Pin 13: Remote External Tally Control (Pos 2)
Pin 14: Remote External Tally Control (Pos 1)
Pin 12: Remote External Tally Control (Pos 3)
Pin 11: Remote External Tally Control (Pos 4)
Pin 15: A Ground
Viewed From OUTSIDE The Console