User manual

89
The detail information as below:
1. Please shut down the power of PC when you plug in the sensor cable into the DVR board,
otherwise it will cause the sensor damage.
2. Make sure that the sensor itself is not covered and is facing the place from where you will
be using the remote controller.
3. Make sure that the sensor itself plug into the phone jack completely.
4. The system allows to extent sensor cable (Fig 8) for control the TV out from far away site
via Remote Controller. Please follow the process as below to achieve this function:
a. Please use the shading cable such as 28#2C+S type.
b. The sensor cable includes 3 wire cable: Red (DC 5V), Shading cable (Ground),
White (Signal). If the extension sensor cable over 40 meters that needs DC 5V extra
power for the sensor operation.
Digi-1600Pro
Digi-1600Pro DVR board provides 2 VGA out and 3 TV out ports. The most functions same as
CP-3200RD, so please refer to the above description.
Setup the Pop up TV out when camera is triggered
Cconfigure the camera correspondence of TV out when triggered, refer the window as below.