User manual

68
Setup NetCom Module sensor
Click “Setup NetCom Module sensor” tab on setup I/O port, you will the window as Fig. 7-8.4.
Follow the instructions below to complete setting.
Step 1. Choose a Sensor in pull-down menu. Enter location of specified sensor in “Location” box.
Step 2. Choose sensor type (NC or NO) in “Type” box.
Step 3. Select “Enable recording” and/or “Enable snapshot” and/or “Enable sound alarm”
and/or “Enable notification” and/or “Trigger speed dome” and “Enable TV out”
configure their corresponding options to the right.
 Enable recording: select camera you want to record when emergency call is pressed.
 Enable Snapshot: select camera to snapshot when emergency call is pressed.
 Enable sound alarm: You can set each camera to have its own unique alarm sound.
For detail please refer Chapter 7-4 of Software operation manual.
 Enable notification: See details on how to set up Notification in Chapter 7-13 &
7-14 of Software operation manual.
 Trigger speed dome: See details on how to set up position in Chapter 7-16 of
Software operation manual.
 Enable TV out: See details on Video Matrix out in Chapter 7-18 of Software
operation manual.
Step 4. Select the specific trigger relays to use from Relay 01 to 03(Back Panel). It also can
trigger the relays of each NC-180AZ module.
Step 5. Enter ”Post recording” time to continue recording after sensor is triggered.
Step6. Click “OK” to finish.
Emergency call Click on icon to set up “I/O configuration” tab, and you should see the
following window, as Fig 7-8.1. Upon pressing a panic button (hardware add-on), you can have
the emergency call feature sound an alarm, notify someone, start recording or show live video feeds
on linked TV sets.
Please follow the instructions below:" “Emergency call” is pressed; if you would have an alarm
sounded, notification sent to somebody, start to recording or show video on TV please follow the
instructions Step 3-6 of Setup NetCom Module sensor as the above.