User manual

67
Setup relay (Fig.7-8.1)
Click “Setup relay” tab, the window as above right one will be shown. Follow the instructions
below to complete setting.
Control: You need to specify the device for setting.
No/Name: Enter “Controller name” corresponding to the desired relay number.
Duration: Enter the controller’s working period when relay trigger.
OK: Click to accept setting. Copy: Copy the parameter setting to another relay.
Cancel: Discard changes in parameter.
Fig. 7-8.3 Fig. 7-8.4
Control NetCom Module relay
Click “Control NetCom Module relay” tab on setup I/O port, as Fig.7-8.3, you can control the
relay out manually or trigger by sensors. The purpose of this tab is testing, remote controlling and
manual control controller.