User manual

19
4-1. Display Properties
Follow up the steps to configure VGA card:
1. Please plug the DVI to VGA converter to the DVI port and then connect to two monitors on the
VGA port before you start to use the DVR. The default setting of VGA support dual monitors.
2. If you use one monitor which you need to connect the monitor on the VGA ports and the DVR
will detect single monitor automatically.
3. If you connect one monitor and click “ Save “ icon to save the DVR configuration. You want to
change to use dual monitors, please following the steps to configure the setting of VGA again.
a. Connect two monitors on the DVR before you start set up the VGA configuration.
b. Click
for configuration Display and then it will show as Fig. 4-1.1.
c. Click “ Setup “ tab, “ Advanced “and then it will show as Fig. 4-1.2.
d. Select “ Goforce MX 4000 “ tab, “ nView display mode “and then it will show as Fig. 4-1.3.
e. Click “Horizontal Span “ item from “nView Modes “.
f. Click “ Ye s “ icon to save the configuration. Fig. 4-1.4.
g. Click
icon to save the setting parameter into the Flash memory to complete configuration
Fig. 4-1.1 Fig. 4-1.2