User manual

113
9-9. Remote Setting the Parameters of DigiCap II DVR
FreeView Pro allows remote client to control the DigiCap II DVR server via EzRClient program
through Internet or Intranet. The Remote client can set up the DigiCap II server from remote site
such as operating at the local. Control the DigiCap II DVR server by through the following steps:
Step 1. Connect to the Internet with your remote client computer and DigiCap II DVR server first.
Step 2. On DigiCap PRO/XP Server site Click icon to enable the Remote Server-
EzRServer program and you should see below window (Fig 9-9.1). Enter “Password”
and save it. Keep the EZRserver program running.
Step 3. On FreeView Pro Client site Click on the bottom Tool bar of FreeView Pro and
you should see below window. (Fig 9-9.2)
Fig 9-9.1 Fig 9-9.2
Step 4. Create a specified user account name in Local EzRclient program before connecting.
Step 5. Entry the IP address/ID Code, Password and then press “Connect” button to connect to
the DVR sit. The number of “TCP/IP Port” must be matched between both sites.
Step 6. Click “Add” to save above information, then you can easily select when you connect again.
Step 7. Click “Exit” icon near the middle right of Control window to disconnect.
Note: When enable “View only”; you can view the window of local site server only when the
server is connected.
Step 8. Click “Add” to save above information, then you can easily select when you connect again.
Step 9. Click “Exit” icon near the middle right of Control window to disconnect.