Installation Guide

AmDry Installation Guide

Tip: to check that your top plate framing is installed

at the proper angle in the corners, measure 2’ and

mark on one side of the corner, measure and mark

3’ on the other side of the corner. The distance

between the two marks on the top plate should read

5’ when measured across the angle.

5) Using a plum string measure from the top plate to

the basement floor or sub floor panel to determine the correct

location to install the bottom horizontal plate, install this

around the entire room. The bottom plates will be fastened

directly to the Amdry ISP (if this has been previously

installed) or fastened directly into the concrete basement floor

using appropriate concrete fasteners. Double check that the

angle is correct from the top place by using the tip in step #4.

6) IMPORTANT. Make sure you pre plan where your electrical

outlets and switches are to be placed. Once you have installed

the bottom horizontal plates around the entire room lay the

electrical wire behind these bottom plates as the electrical

wiring will be installed as the IWP are being placed.

The electric wire will be secured by electric staples on

the vertical wall studs as the installation progresses.

Note: the electrical wiring will need to follow the local

building code requirements, inspected by and

connected to the electrical service a qualified electrical

professional.

7) Install the corner vertical studs in each of the corners

of the room the studs will be installed so that the 1.5”

(3.91 cm) stud facing is open on each side of the corner as

shown in the picture.

8) You are now ready to install the first IWP. Measure the height

of the wall, If the wall height is less than 96” (244 cm) you will

need to cut the IWP to the proper height.