Installation Guide

AmDry Installation Guide
dimension as in step # 8 remember to remove the 1.5” (3.81 cm) of foam where you
have made the cut. You will not need to remove any foam form the side of the remaining
panels until you come to the end of the wall or a jog out or in. Repeat step # 10 until to
come to the end of the wall. Remember to tack the electric wire to all vertical studs as
you are installing the IWP.
12) Once you reach the end of the wall you may need to cut the last panel vertically to fit in
this area if this dimension is less that 24”. In any case you will need to remove the foam
from the end side of the panel to the measurement of
the pre installed corner vertical stud. Follow directions
as in step #9
13) Repeat this process for the balance of the room.
5