Installation Guide

AmDry Installation Guide
4
Step 2:
For the 2
nd
row; start back at the original starting
point beside the first panel placed. Place 2 spacers at
the wall.
While we recommend that you stager the panels in
each row to provider added strength. To install the
Amdry panels in a staggered pattern cut a 2’ x 4’
Amdry panel in half, measure the panel @ 24” place
a mark on either side, using the straight edge mark
the center of the panel, place a piece of 2x4 under the
panel at either end, and using the circular saw with
the plywood blade cut the panel. As an alternative
you can use the leftover piece form the last panel in
the first row. Slide the 2’ x 2’ cut panel into the long
end side connector of the first panel using the tapping
block to secure, continue to lay the second row of
panels with the 2’ x 4’ Amdry panels. Place the 4’
AmDry connector into the 2
nd
row of installed panels.