User manual

19 Chapter 3
• LAN1 Controller [Enabled]
This item is enabled or disabled that onboard of LAN1 controller. Bios
default value suggest to “Enabled”.
• LAN2 Controller [Enabled]
This item is enabled or disabled that onboard of LAN2 controller. Bios
default value suggest to “Enabled”.
• ITE8888 Configure [Press Enter]
This item allows user to changed ITE8888 of detail adjust.
• IDE HDD Block Mode [Enabled]
This item allows enabled or disabled that IDE block data transfer mode.
It will speed up HDD data transfer of efficiency. Bios default value sug-
gest to “Enabled”.
• LPT/FDC switch: [Disabled]
This item is switch LPT/FDC port by item. It will changed from LPT to
FDC port. Bios default value suggest to “Disabled”.
• Onboard Serial Port 1 [3F8]
This item allows user to change com 1 of address. Bios default value
suggest to “3F8”.
• Onboard Serial Port 1 use [IRQ4]
This item allows user to change com 1 of IRQ. Bios default value sug-
gest to “IRQ4”.
• Onboard Serial Port 2 [2F8]
This item allows user to change com 2 of address. Bios default value
suggest to “2F8”.
• Onboard Serial Port 2 use [IRQ3]
This item allows user to change com 2 of IRQ. Bios default value sug-
gest to “IRQ3”.
• Onboard Serial Port 3 [3E8]
This item allows user to change com 3 of address. Bios default value
suggest to “3E8”.
• Onboard Serial Port 3 use [IRQ10]
This item allows user to change com 3 of IRQ. Bios default value sug-
gest to “IRQ10”.
Data Modul AG - www.data-modul.com