User manual

13 Chapter 2

2.5 Installing SO-DIMM

The procedures for installing SODIMMs are described below. Please fol-

low these steps carefully. You can install SDRAM memory modules

using 200-pin SODIMMs (Small Outline Dual In-line Memory Modules).

1. Ensure that all power supplies to the system are switched off.

2. Tilt the SODIMM card approximately 25° above the board, and

move it in the direction of the housing card slot. Make sure that the

key in the module and the key in the housing are aligned.

3. Push the module into the socket until the module bottoms. There

should be a slight insertion force to engage the module into the con-

tacts.

Module Key Aligned

With housing Key

Module Tilted

Approximately 25

Module Latching

Ledge(TO Engage

Edge of Module)

Housing

Card Slot

PC Board

Data Modul AG - www.data-modul.com