User guide

Display Controller User Guide 37
"Always trust software from Barco" and press OK. The PnPUtil application
will confirm the driver is loaded into the driver store.
At this point you can change to another directory and repeat this with
other drivers. You will not see the trust prompt.
If you install using wildcards, you may see an error message that the
Autorun.inf was not in an expected format. This message is normal and
can be ignored.
When you have added all of the drivers that you will need to the driver
store, you can create an image of the drive, and use it for staging
additional systems. All of the systems with this driver store are set up for
intervention-free silent installation.
SILENT INSTALLATION
For silent installation, first import the Barco published certificate into the
certificate store. This certificate can be extracted from the driver catalog
file located in the driver package. Please note that the certificate changes
overtime, so we recommend extracting the current one each time.
Once imported, navigate to the Barco installation folder and execute the
command "setup.exe -silent". This can be done from the command shell,
from the Run command, or from a command shortcut. The setup program
will automatically install the drivers for any BarcoMed or MXRT boards
that are present, the BarcoMed Self Exam program, and QAWeb (if part of
the installation package).
CONFIGURE SILENT INSTALL OPTIONS:
You can modify the setup.ini file at the Barco root folder to customize
some silent install options. The configurable options are listed in the
[Custom] section of the setup.ini file.
SimplifiedFinishPage: If set to Yes, only the Finish button appears on the
final installation page. If No (default), reboot buttons and show document
check boxes are also shown.
Reboot: If set to Yes (default), the installer will prompt the user or launch
a timer to reboot following software installation. If No, the prompt/timer
is not shown.