User guide

Display Controller User Guide 11
Installation procedure
The following instructions will take you step by step through the
installation of the BARCO DISPLAY CONTROLLER (S) for your BARCO DISPLAY SYSTEM.
Wear a grounded, protective ESD strap when handling or
during installation of the display controller. Electrostatic
charges can damage the display controller.
1 If you are not going to use your old display controller, uninstall its
drivers and software if you have not already done so.
2 Turn off the computer, display(s), and other peripheral devices.
3 Unplug the computer from
the back of your computer.
Wait approximately 20 seconds after unplugging the
power cord before disconnecting a peripheral or
removing a component from the motherboard to avoid
possible damage to the motherboard.
4 Remove the computer cover. If necessary, consult your computer
manual for instructions.
5 If necessary, unscrew or unfasten and remove any existing display
controller(s) from your computer.
If you are using a motherboard containing an on-board
graphics solution and do not intend to use it as part of a
multiple-display setup, disable it either in the computer
System Set-up utility (BIOS) or the Windows device
manager.
6 Locate the appropriate slot and, if necessary, remove the metal
back-plate cover(s).
7 Align the BARCO DISPLAY CONTROLLER (S) for your BARCO DISPLAY SYSTEM
with the slot(s) and press it(them) in firmly until the card(s) is(are)
fully seated.