User guide

5. Driver and software features

Clone display menu options

Right clicking on the cloned image will bring up the Conference CloneView context menu and offers the

following options:.

• Show GUI: This option launches the conﬁguration window. When the conﬁguration window is already

shown, this option is grayed out.

• Minimize: This minimizes the cloned image to show the desktop.

• Zoom to 1:1 Aspect Ratio: When ”Stretch to ﬁll”isselectedintheconﬁguration window, the aspect

ratio of the cloned image may not match the source. Select this option to zoom directly to a 1:1 aspect

ratio. When ”Stretch to ﬁll” is n ot selected, this option is grayed out.

• Reset Zoom Level: Select this option to return to the minimize zoom level. When the image is already

at the minimum zoom level, this option is grayed out.

• Stop Cloning: Select this option to stop cloning on the current Display Controller. It has the same

effect as clicking on the Stop cloning buttonintheconﬁguration window.

5.2 Sing leView

5.2.1 Description

Overview

SingleView enables the use of the entire display as one display, and eliminates any tearing down the

center of the display. This simple setting works with your current PACS software to allow for hanging

protocols in the center of the display.

Image 5-4

Supported displays

SingleView is available on all Coronis Fusion displays.

Default behavior

SingleView is not enabled by default unless selected in the Custom Installation Options.

5.2.2 Conﬁguration

Conﬁguring SingleView

Click on the BarcoView Systray icon and select SingleView. In Windows 7, the conﬁguration menu is also

accessible through the Start Menu. This shows 3 options:

• DualView Mode: Select this option to show the two halves of the Fusion display as two separate

displays.

• SingleView Mode: Select this option to show the two halves of the Fusion display as a single large

display.

• Swap SingleView Left & Right: If the left half and right half of the Fusion display appear out of

order in SingleView mode, select this option. (Use the Windows Control Panel to correct their order

in DualView)

K5905271 DISPLAY CONTROLLER 27/02/2015