User guide

3. Driver and software installation
At this point you can change to another directory and repeat this with other drivers. You will not see the
trust prompt.
If you install using wildcards, you may see an error message that the Autorun.inf was not in an expected
format. This message is normal and can be ignored.
Once a Barco driver has been pre-loaded into the driver store of a Windows 7 OS, sub-
sequent installation of the driver will be intervention-free.
When you have added all of the drivers that you will need to the driver store, you can create an image of
the drive, and use it for staging additional systems. All of the systems with this driver store are set up for
intervention-free silent installation.
Silent installation
For silent installation, first import the Barco published certificate into the certificate store using standard
Windows tools and processes, such as Certutil. This certificate can be extracted from the driver catalog
file located in the driver package. Please note that the certificate changes overtime, so we recomme
nd
extracting the current one each time.
Once imported, navigate to the Barco installation folder and execute the command setup.exe -silent.
This can be done from the command shell, from the Run command, or from a command shortcut. The
setup program will automatically install the drivers for any BarcoMed or MXRT boards that are present,
the BarcoMed Self Exam program, and QAWeb (if part of the installation package).
Configure s ilent install options
You can modify the setup.ini file at the Barco root folder to customize s
ome silent install options. The
configurable options are listed in the [Custom] section of the setup.ini file.
SimplifiedFinishPage:
• If set to Yes, only the Finish button appears on the final installation page.
• If No (default), reboot buttons and show document check boxes are also shown.
Reboot:
• If set to Yes (default), the installer will prompt the user or launch a timer to reboot following software
installation.
• If No, the prompt/timer is not shown.
DisableCalibrationSoftwareText:
• If set to Yes (default), QAWeb software is installed.
• If No, the user can select installation of either QAWeb and/or MediCal Pro, if present.
IgnoreInstallFailureOnReboot:
• If set to Yes, the system will disregard any installation failures and proceed to auto-reboot.
• If No (default), the auto-boot is disable if instal
lation failures are detected.
DisableQAWebScripts:
• If set to Yes, QAWeb will auto-start.
• If No (default), scripts will prevent QAWeb from launching until after the reboot.
NeverForceUninstall:
• If set to Yes, the installer will not require the user to uninstall previous Barco drivers.
• If No (default), the installer prompts the user to uninstall pre-existing drivers.
K5905271 DISPLAY CONTROLLER 27/02/2015
25