User guide

3. Driver and software installation
5. Click Yes to accept the driver’s License Agreement, and then Next to continue.
6. You will be prompted for Express or Custom Installation.
By default, the Express Install option is selected. Custom Installation prompts two installation options:
- 24-bit Desktop: This disables the default 30-bit desktop mode that provides high dynamic range
visualization.
- SingleView: This option sets all Barco Fusion displays into SingleView mode.
7. During installation, the desktop may flash, and the Installation Wizard window may appear on different
displays. This is expected behavior.
8. When the installation of all components has completed, the automatic reboot window will be displayed.
Allow the system to reboot.
3.3 After installation
Installation verification
To verify that the driver was installed, go to the Windows Control Panel,selectSystem, select Device
Manager, then select Display Adapters. Verify that Barco Display Controllers are properly identified, as
shown below:
Image 3-2
Verifying driver installation
Automatic display configuration
Once the drivers, software and documentation have been installed and your system has been rebooted,
the computer will automatically detect your Barco displays and attach them to the desktop with the cor-
rect resolution. If the computer fails to detect your Barco displays or fails to attach them to the desktop
correctly, please use the Windows Screen Resolution to set the correct resolution.
Reinstalling drivers
You can install new drivers or reinstall existing drivers at any time by using the Barco Set-up wizard on
your Barco Display System Installation DVD.
Uninstalling the drivers and software
To uninstall the Barco drivers, software or documentation for your Barco Display System, please use the
Windows Add/Remove Programs. This can be found in the Windows Control Panel under Programs
&Features.
K5905271 DISPLAY CONTROLLER 27/02/2015
23