User guide

2. Display Controller installation
The Dual-Link dongle is ordered separately.
How to install the Dual-Link Dongle
Use the following steps to install the dongle:
1. Connect the DisplayPort end of the connector to the Display Controller.
Image 2-9
1
To computer’s USB port
2
To display (DVI Dual-Link)
3
To DisplayPort connector on Barco Display Controller
2. Plug in a Dual-Link DVI cable from the display to the DVI port of the dongle.
3. Connect the built-in USB power cable on the dongle to a workstation USB port.
4. If you are using QAWeb Agent version 1.10.2 or older, a separate software component is re-
quired for supporting DDC communication through the Dual-Link dongle. Run setup.exe from
Barco_DLDP2DVI_Install package after driver installation to install the SW.
Image 2-10
1
Up to 3MP color
2
9’ Barco DVI cable
3
Dual-Link DP to DVI adapter
4
USB power connector
2.5.4 Common cases
MXRT-2400 & MXRT-2500
All grayscale or 2MP color diagnostic displays
10
K5905271 DISPLAY CONTROLLER 27/02/2015