Specifications
Table Of Contents
- Notices
- Safety information
- About this guide
- M4A88T-M LE specifications summary
- Chapter 1
- Product introduction
- Chapter 2
- BIOS information
- 2.1 Managing and updating your BIOS
- 2.2 BIOS setup program
- 2.3 Main menu
- 2.4 Ai Tweaker menu
- 2.4.1 CPU OverClocking
- 2.4.2 CPU Ratio
- 2.4.3 DRAM Frequency
- 2.4.4 CPU/NB Frequency
- 2.4.5 HT Link Speed
- 2.4.6 GPU OverClocking
- 2.4.7 DRAM Timing Configuration
- 2.4.8 DRAM Driving Configuration
- 2.4.9 CPU & NB Voltage Mode
- 2.4.10 CPU VDDA Voltage
- 2.4.11 DRAM Voltage
- 2.4.12 HT Voltage
- 2.4.13 NB Voltage
- 2.4.14 NB 1.8V Voltage
- 2.4.15 SB Voltage
- 2.4.16 CPU Load-Line Calibration
- 2.4.17 CPU/NB Load-Line Calibration
- 2.4.18 PCI/PCIe CLK Status
- 2.5 Advanced menu
- 2.6 Power menu
- 2.7 Boot menu
- 2.8 Tools menu
- 2.9 Exit menu
7. USB connectors (10-1 pin USB78, USB910, USB1112)
These connectors are for USB 2.0 ports. Connect the USB module cable to any of
these connectors, then install the module to a slot opening at the back of the system
chassis. These USB connectors comply with USB 2.0 specication that supports up to
480Mbps connection speed.
Never connect a 1394 cable to the USB connectors. Doing so will damage the
motherboard!
The USB 2.0 module is purchased separately.
8. Serial port connector (10-1 pin COM1)
The connector is for a serial (COM) port. Connect the serial port module cable to the
connector, then install the module to a slot opening at the back of the system chassis.
The serial port module is purchased separately.
ASUS M4A88T-M LE 1-27